(No soldering, no pinout reviewing, no pin counting, saves lots of time and hassle and let’s you make your job faster, precise and easier) Slide the Adapter over the soldered PLCC MCU on the target PCB.
Select the VCC supply source by the jumper on the mainboard next to the ISP connector (on = target supplied from upa, off = target got own supply). Pick the Adapter you want to use, attach the flat cable to the Adapter (PIN1 is always indicated, on both the cable and also the Adapter) and also to the main board’s 10pin ISP connector. You can also use the included DIL to 10pin Flat-ribbon header, put it inside the ZIF socket and wire up an SOIC clip or clamps for ISP use from there.
It can also support PCI-E, eMMC and UFS device duplicating.
MOTOROLA EEPROM PROGRAMMER 01 P35991A001 SERIES
Insert the correct config key into the slot of the mainboard and start programming either via the ZIF or SOIC Socket. NuProgPlus Series is the powerful universal programmer which is capable of supporting EEPROM, Flash, MCU, eMMC, UFS, PCI-E SSD, and CANbus devices programming. Simply connect the mainboard to the UPA USB programmer directly or by using a DB9 male / female extension cable (1:1).
MOTOROLA EEPROM PROGRAMMER 01 P35991A001 CRACKER
USB driver upausb.sys is digitally signed motorola GP 360 programming software : Forum Matches - Check > Found in: fulltext index (78) RadiusGM-300 service software.zip: 16/12/07: Radio Programming Software: 231 kB: 6702: Motorola: Radius GM-300: Motorola cracker 41.3.zip: 28/04/04: This software allows reading and writing internal EEPROM in Motorola MCUs Special interface is.
0 kommentar(er)
